Examples of Industries employing MEs

Many industries employ mechanical engineers; a few industries and the type of systems MEs
design are listed below.

Automotive
• Combustion
• Engines, transmissions
• Suspensions
Aerospace (w/ aerospace engineers)
• Control systems
• Heat transfer in turbines
• Fluid mechanics (internal & external)
Biomedical (w/ physicians)
• Bio-mechanics – prosthesis
• Flow and transport in vivo
Computers (w/ computer engineers)
• Heat transfer
• Packaging of components & systems
Construction (w/ civil engineers)
• Heating, ventilation, air conditioning (HVAC)
• Stress analysis
Electrical power generation (w/ electrical engineers)
• Steam power cycles - heat and work
• Mechanical design of turbines, generators
Petrochemicals (w/ chemical, petroleum engineers)
• Oil drilling - stress, fluid flow, structures
• Design of refineries - piping, pressure vessels
Robotics (w/ electrical engineers)
• Mechanical design of actuators, sensors
• Stress analysis

Comments

What is difference between plane angle and solid angle?

A plane angle is one that can be measured completely within a plane. This may be because the angle occurs in a 2-D space, or it is an angle that is contained completely within a plane that is in a 3-D (or higher-D) space. So the angles in a triangle are plane angles, because they are in a plane. Similarly, the angles in a spherical triangle are plane angles, because even though they measure things in a 3-D space, they can always be shown to be wholly within a plane. Another way to consider a plane angle is to think of angles within a circle. You can divide the circle up into 2π radians, for example, or 360°, or 400 gon, or whatever units you choose. However, the radian as a unit is defined by the subtended arc length that is equal to the radius of the circle. A steradian, the basic unit, is solid angle is one that is subtended by a portion of the surface area of a sphere that is equal to r^2, where r is the radius of the sphere. It can be considered to be a cone subtended at...

Combined-Cycle Power Plant

Combine Power Plant use both Gas Turbine and Steam Turbine to produce energy. Natural gas use for gas turbine.The exhaust heat of gas turbine use in steam turbine. A schematic diagram are given below: Combined Cycle Generation Process

Choosing Between Mechanical Fuel Pump And Electric Fuel Pump?

Fuel Pump A f uel pump is a frequently (but not always) essential component on a car or other internal combustion engined device. Many engines (older motorcycle engines in particular) do not require any fuel pump at all, requiring only gravity to feed fuel from the fuel tank or under high pressure to the fuel injection system. Often, carburated engines use low pressure mechanical pumps that are mounted outside the fuel tank, whereas fuel injected engines often use electric fuel pumps that are mounted inside the fuel tank (and some fuel injected engines have two fuel pumps: one low pressure/high volume supply pump in the tank and one high pressure/low volume pump on or near the engine). Fuel pressure needs to be within certain specifications for the engine to run correctly. If the fuel pressure is too high, the engine will run rough and rich, not combustion all of the fuel being pumped making the engine inefficient and a pollutant. I...

Mechanical Engineering

Search This Blog